[amibroker] Constructing a Range Bound Indicator

["dmcleod1981" <dmcleod1981@xxxxxxxxx>]

I have an indicator that is built using add to composite that normally
plots between 0 and 1. However, occasionally it will go negative or
over 1. How can I adjust my composite so that as it is being built it
will not go below 0 or above 100. I don't want to limit the individual
negative values but only if the composite goes negative or over 1.
Does that make sense?

Thanks
DM



Please note that this group is for discussion between users only.

To get support from AmiBroker please send an e-mail directly to 
SUPPORT {at} amibroker.com

For NEW RELEASE ANNOUNCEMENTS and other news always check DEVLOG:
http://www.amibroker.com/devlog/

For other support material please check also:
http://www.amibroker.com/support.html
 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/amibroker/

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    http://groups.yahoo.com/group/amibroker/join
    (Yahoo! ID required)

<*> To change settings via email:
    mailto:amibroker-digest@xxxxxxxxxxxxxxx 
    mailto:amibroker-fullfeatured@xxxxxxxxxxxxxxx

<*> To unsubscribe from this group, send an email to:
    amibroker-unsubscribe@xxxxxxxxxxxxxxx

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/